The challenge
When producing pre-cooler of compressed air, it is of utmost importance that the moisture is removed from the air. If not removed properly the moisture can cause problems with the use of pneumatic tools, cause corrosion, can freeze and damage the piping etc. Due to these facts dryers of different kinds are a standard component in the treatment of pre-cooler of compressed air. The dryers function is to remove the moisture from the air. However, the air entering the dryer is in some cases pre-cooled to remove moisture already before entering the dryer. This allows the end customer to use a smaller and more cost-efficient system solution. Pre-coolers should be efficient, compact and not take up too much floor space to create a cost-efficient solution.
The solution
The pre-dominant pre-cooler of compressed air solution on the market today is Shell and Tube type heat exchanger. Shell and Tube Heat Exchangers are a proven design, yet they are known to be bulky and highly inefficient. They take up a lot of floor space due to its long shell.
This design has unique advantages as pre-cooler due to its high efficiency, excellent condensing capacity and compact design.
The result
Together with our customers, we have successfully installed pre-cooler of compressed air adsorption dryers. Innovative brazed plate technology provides the end customer with several benefits. Not only does it remove the moisture and lower the temperature just like the Shell and Tube. The design has an even higher condensing effect, it is also much smaller saving a lot of valuable floor space. It has much lower weight and is easier to handle. Additionally, the compact design has created a very cost-efficient solution saving money for the end customer.
This article comes from mynewsdesk edit released
